No. 2661988·thrash-metal·4 blocks

Harvester of Sorrow

Harvester of Sorrow is the slow one on ...And Justice for All, a mid-tempo grind at about 92 BPM, built on riffs Hetfield first demoed in 1987. The rig is the album's: an ESP Explorer-style guitar with EMGs into a Mesa/Boogie Mark IIC+, with a B&B parametric EQ that Flemming Rasmussen put in the amp's effects loop. Then the mix pulled the bass almost out. At this tempo the low strings ring longer, so the setup leaves a little more sustain and a softer gate than the fast Justice songs.

...And Justice for All cover...And Justice for All
Settings for
Signal path · input → output · 7 blocksLive values · Line 6 Helix
Guitar
1987 ESP MX220 'Eet Fuk' (Explorer style)
Pickups
HH (bridge)
Tuning
Standard
Strings
.010-.046 (not documented for the sessions)
Noise Gate
Deluxe Comp
Cali IV Lead
4x12 Uber T75
Parametric
Volume Pedal
Noise Gate
← Gain-structure housekeeping
Effect
Threshold
-50dB
Decay
35s
Deluxe Comp
← Tape and console compression
Dynamics
Threshold
-30dB
Ratio
2:1
Knee
6dB
Attack
35ms
Release
220ms
Mix
30
Level
0dB
Cali IV Lead
← Mesa/Boogie Mark IIC+ (lead channel)
Amp
Drive
6.5
Bass
3
Mid
3.5
Treble
7.5
Presence
6
ChVol
6
Master
8
Bias
5.5
BiasX
5
Sag
5
Hum
4
Ripple
4
4x12 Uber T75
← Two 4x12 cabinets
Cab
LowCut100Hz
HighCut8500Hz
Resonance
4
Level
0dB
Pan
0.5
Delay
0
Parametric
← B&B Audio parametric EQ in the loop
EQ
LowFreq
150
LowGain
-2
MidFreq
750
MidGain
-2.5
HighFreq
3500
HighGain
1
Level
0
Volume Pedal
← Output level
Volume/Pan
Pedal
100%

What we checked

Computed by a program, on this recipe, every time this page is built. How this works

Preset files — 1 of 3 complete
  • Helix builds complete — every block in the recipe is in the file
  • Quad Cortex 3 blocks replaced with a stand-in model
    Which ones

    Replaced with a stand-in: Noise Gate, Studio Compressor, CA MkCC+. These load cleanly but are not the model named above — the file will sound wrong here until we map them. Set these blocks by hand.

  • Katana 2 blocks replaced with a stand-in model
    Which ones

    Replaced with a stand-in: Brown, Noise Suppressor. These load cleanly but are not the model named above — the file will sound wrong here until we map them. Set these blocks by hand.

Helix DSP
49.5% of one chip — fits (1 block has no published cost and is counted as zero)
Sources
4 cited, 3 from publications that do original gear reporting
Attribution
Documented — The player is named for this specific part in credits or an interview.
What we didn't check
  • Nobody played this through a real amp. There is no human listening test behind any number on this page.
  • The settings are reasoned from the sources below, not measured off the record.
  • No audio has been rendered for this recipe yet, so you cannot hear it before you load it.
  • 3 platforms on this page (TONEX, Kemper, Fractal) get a model pointer, not a preset file — nothing was built or checked for them.

Rate This Tone

...

(0 ratings)

Sign in to rate this recipe.

Comments

Sign in to leave a comment.