No. 2641969·hard-rock·3 blocks

Heartbreaker

The unaccompanied break in Heartbreaker is Page alone: the band stops and he plays a free-time solo, then they crash back in. By his own account it was cut separately, at Atlantic Studios in New York, which is why it sounds different from the A&R track around it. He has named it as his first recording with a Les Paul into a Marshall, though one history of the album disputes that. This recipe follows Page's version and says so.

Led Zeppelin II coverLed Zeppelin II
Settings for
Signal path · input → output · 7 blocksLive values · Line 6 Helix
Guitar
Gibson Les Paul Standard (late 1950s)
Pickups
HH (bridge)
Tuning
Standard
Strings
not documented (light gauge)
Volume Pedal
Deluxe Comp
Brit Plexi Brt
4x12 Greenback25
Parametric
Plate
Volume Pedal
← Guitar volume knob
Volume/Pan
Pedal
100%
Deluxe Comp
← Tape and console compression
Dynamics
Threshold
-24dB
Ratio
2:1
Knee
4dB
Attack
30ms
Release
150ms
Mix
20
Level
0dB
Brit Plexi Brt
← Marshall head (model not documented)
Amp
Drive
7
Bass
5
Mid
7
Treble
6.5
Presence
6
ChVol
6
Master
10
Bias
6
BiasX
5
Sag
6
Hum
4
Ripple
4
4x12 Greenback25
← Marshall 4x12 (not documented)
Cab
LowCut80Hz
HighCut7500Hz
Resonance
5
Level
0dB
Pan
0.5
Delay
0
Parametric
← Console EQ
EQ
LowFreq
120
LowGain
-1.5
MidFreq
1200
MidGain
1.5
HighFreq
6500
HighGain
-1
Level
0
Plate
← Studio room / plate
Reverb
LowCut200Hz
HighCut6000Hz
Mix
12
Decay
1.4s
Level
0
PreDelay
15ms

What we checked

Computed by a program, on this recipe, every time this page is built. How this works

Preset files — 1 of 3 complete
  • Helix builds complete — every block in the recipe is in the file
  • Quad Cortex 3 blocks replaced with a stand-in model
    Which ones

    Replaced with a stand-in: Studio Compressor, Brit Plexi 100 Bright, 4x12 Brit 25. These load cleanly but are not the model named above — the file will sound wrong here until we map them. Set these blocks by hand.

  • Katana 2 blocks replaced with a stand-in model
    Which ones

    Replaced with a stand-in: Crunch, Plate. These load cleanly but are not the model named above — the file will sound wrong here until we map them. Set these blocks by hand.

Helix DSP
53.1% of one chip — fits (1 block has no published cost and is counted as zero)
Sources
3 cited, 2 from publications that do original gear reporting
Attribution
Documented — The player is named for this specific part in credits or an interview.
What we didn't check
  • Nobody played this through a real amp. There is no human listening test behind any number on this page.
  • The settings are reasoned from the sources below, not measured off the record.
  • No audio has been rendered for this recipe yet, so you cannot hear it before you load it.
  • 3 platforms on this page (TONEX, Kemper, Fractal) get a model pointer, not a preset file — nothing was built or checked for them.

Rate This Tone

...

(0 ratings)

Sign in to rate this recipe.

Comments

Sign in to leave a comment.