No. 1342008·nu-metal·6 blocks

Psychosocial

The crushing drop-A riff from All Hope Is Gone. Per Mick Thomson's 2008 Guitar World interview, the rhythm tracking was a Marshall JCM800 2203 with a Maxon overdrive in front — the boost set low to tighten the very low tuning, not to add gain. Jim Root's side blended an Orange Rockerverb 100 with a Diezel Herbert. Cut with Dave Fortman at Sound Farm in Iowa, the tone is a tight, mid-present Marshall high-gain built to keep the low A articulate.

All Hope Is Gone coverAll Hope Is Gone
Settings for
Signal path · input → output · 8 blocksLive values · Line 6 Helix
Guitar
Ibanez MTM1
Pickups
HH
Tuning
bridge
Strings
drop A (A-E-A-D-F#-B)
Noise Gate
Deluxe Comp
Scream 808
Brit 2204
4x12 Uber V30
Room
Tilt
Noise Gate
← Noise gate
Cab
Threshold
-46dB
Decay
0.2s
Level
0
Deluxe Comp
← Tracking compression
Dynamics
Threshold
-30dB
Ratio
2:1
Knee
6dB
Attack
40ms
Release
200ms
Mix
30
Level
0dB
Scream 808
← Maxon OD-820 Overdrive Pro
Distortion
Drive
0.1
Tone
0.6
Level
0.8
Brit 2204
← Marshall JCM800 2203 (Thomson)
Amp
Drive
8
Bass
5
Mid
6
Treble
6.5
Presence
7
ChVol
6
Master
7
Bias
5
BiasX
5
Sag
4
Hum
4
Ripple
4
4x12 Uber V30
← Marshall/Orange 4x12 with V30 / G12K-100
Cab
LowCut105Hz
HighCut8000Hz
Level
0dB
Pan
0.5
Delay
0
Room
← Studio ambience (minimal)
Reverb
LowCut170Hz
HighCut6000Hz
Mix
0.1
Decay
0.2s
Predelay
8ms
Level
0
Tilt
← Global brightness EQ
EQ
Tilt
0.5
CenterFreq
1000Hz
Level
0

What we checked

Computed by a program, on this recipe, every time this page is built. How this works

Preset files — 1 of 3 complete
  • Helix builds complete — every block in the recipe is in the file
  • Quad Cortex 5 blocks replaced with a stand-in model
    Which ones

    Replaced with a stand-in: Noise Gate, Studio Comp, Green 808, Room, Tilt EQ. These load cleanly but are not the model named above — the file will sound wrong here until we map them. Set these blocks by hand.

  • Katana 1 block missing from the file; 4 blocks replaced with a stand-in model
    Which ones

    Not in the file: Plate. The recipe calls for this block, but we have no verified model ID for it on this platform, so the preset is written without it. Add it by hand using the settings above.

    Replaced with a stand-in: Lead, Noise Gate, Booster, Plate. These load cleanly but are not the model named above — the file will sound wrong here until we map them. Set these blocks by hand.

Helix DSP
62.3% of one chip — fits
Sources
3 cited, 2 from publications that do original gear reporting
Attribution
Not yet rated — This recipe predates the attribution-confidence field and hasn't been reviewed for it.
What we didn't check
  • Nobody played this through a real amp. There is no human listening test behind any number on this page.
  • The settings are reasoned from the sources below, not measured off the record.
  • No audio has been rendered for this recipe yet, so you cannot hear it before you load it.
  • 3 platforms on this page (TONEX, Kemper, Fractal) get a model pointer, not a preset file — nothing was built or checked for them.
The mic in this chain

Shure SM57

Still made, still the studio default. The cheapest part of this chain to get right.

Affiliate links — we may earn a commission at no extra cost to you, and as an Amazon Associate we earn from qualifying purchases. The mic is listed because the chain uses it, not because anyone paid for the placement.

Rate This Tone

...

(0 ratings)

Sign in to rate this recipe.

Comments

Sign in to leave a comment.